News and Events

A hook-on scaffold plank has formed ends designed to engage a particular support; a plain steel plank relies on a different bearing and restraint detail. The right choice is the one specified for your scaffold system and bay, not the one with a more convenient product name. Check the hook profile or plain-end bearing, the support transom, the locking detail and the manufacturer’s span information before ordering. Ringlock, Kwikstage and frame scaffolding can use different platform support arrangements, even when the boards have similar nominal widths. A plank that rests on a member is not necessarily secured against movement or lift-off. This guide compares the two end styles and gives buyers a five-step fit review. It also explains what to send a supplier when matching new boards to an existing scaffold fleet. Read More

Ringlock scaffolding for shoring uses modular standards, ledgers and braces to help carry temporary construction loads, but the arrangement must be designed around a specific load path. An access scaffold mainly provides working platforms for people and tools. A shoring arrangement may transfer the weight of fresh concrete, formwork, beams or other temporary loads through U-heads, standards and base jacks into a suitable foundation. That change affects the grid, bracing, head and base details, erection sequence and checks before loading. It is unsafe to take an access scaffold bill of materials, add a few extra standards and assume it becomes a shoring design. The project designer needs load cases, component data and ground information. This article sets out five design inputs a buyer should send with an RFQ, so the supplier can quote parts that match the approved temporary-works plan. Read More

A tube and clamp scaffold estimate starts with the approved layout, then counts every tube, coupler, platform and base component needed to build it. A list of vertical tubes and right-angle clamps alone will miss diagonal bracing, sleeve joints, access, edge protection and replacement stock. The quantities also depend on bay geometry, lifts, ties, working-platform levels and the intended loads. A supplier can quote an itemised bill of materials, but the purchase list should not be mistaken for an engineered scaffold design. This article gives seven RFQ line-item groups for contractors and distributors preparing a tube-and-coupler order. It shows which dimensions to provide, where different coupler types belong and why a 40HQ shipping estimate must be based on the final mix of long tubes and boxed fittings. Read More

Ringlock ledger lengths set the scaffold bay grid, but deck supports, diagonal braces and connection details must match the same approved layout. Compare the published 610–1829 mm options, then send your bay drawing for a project quotation.

Read More